meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
sector:ippu:other_solvent_and_product_use:chemical_products:start [2023/06/12 14:15] – [Bitumen blowing] reichelsector:ippu:other_solvent_and_product_use:chemical_products:start [2023/06/16 14:48] – [Bitumen blowing] reichel
Line 76: Line 76:
 == Emission factors == == Emission factors ==
  
-The NMVOC and PAH emissions that result from bitumen blowing are calculated with an emission factor derived from the uncontrolled standard emission factor of the GB 2019 taking account of the maximum permitted levels and reduction-measures requirements specified in the Technical Instructions on Air Quality Control (TA Luft).+The NMVOC and PAH emissions that result from bitumen blowing are calculated with an emission factor derived from the uncontrolled standard emission factor of the GB 2019 taking account of the maximum permitted levels and reduction-measures requirements specified in the Technical Instructions on Air Quality Control (TA Luft). The emission factors for Cd, Cr and Ni were taken from real measurements with an increased safety factor (maximum or ten-fold).
 All emission factors remain constant for all years in question. All emission factors remain constant for all years in question.
  
-__Table 1: Overview of the tier-2 emission factors applied for bitumen blowing__+__Table 1: Overview of the tier-2 emission factors applied for bitumen blowing with post-combustion__
  
 |        ^  EF 2010  ^  Unit  ^  Trend  ^ |        ^  EF 2010  ^  Unit  ^  Trend  ^
Line 91: Line 91:
 ^ PAH    |   2.55    |  mg/t  |  default <sup>[[#Bibliography| (Lit. 2)]]</sup>  | ^ PAH    |   2.55    |  mg/t  |  default <sup>[[#Bibliography| (Lit. 2)]]</sup>  |
  
--------------------------------+=== Trend discussion (for key categories) === 
  
-===== Uncertainties =====+All trends in emissions correspond to trends of emission factors in table above and of production development. No rising trends are to identify.
  
-Emission factors: Relative error rates at ±15% and ±25% (Adhesive manufacturing, magnetic tapes manufacturing, photographs manufacturing) were applied, but not exceeding 100% or falling below 0%. Uncertainties refer to a 95% confidence interval.+[{{sector:ippu:other_solvent_and_product_use:chemical_products:em-NMVOC_2D3g-bitumen-blowing.png | Trend of annual NMVOC and TSP emissions from bitumen blowing }}]
  
 +-------------------------------
 +
 +===== Uncertainties =====
  
 +Emission factors: Relative error rates at ±15% and ±25% (Adhesive manufacturing, magnetic tapes manufacturing, photographs manufacturing) were applied, but not exceeding 100% or falling below 0%. Uncertainties refer to a 95% confidence interval. For bitumen blowing emission factor uncertainties are on a higher level just to 100%. For Cd and TSP the uncertainty are even greater than a factor of two.
 ===== Recalculations ===== ===== Recalculations =====
  
Line 110: Line 114:
 ===== Planned improvements ===== ===== Planned improvements =====
  
 +For bitumen blowing a visual NMVOC emission trend description will be added.
 ===== Bibliography ===== ===== Bibliography =====